HOW TO RESET HUMAX 5400 PRESET DIQESC 1.2 SAT POSITIONS.

note. this procedure does not alter anything other than the diqesc 1.2 prestored positions.

if you want to reset the stored positions back to default, meaning the basic diqesc 1.2
positions prestored in the humax this is what you do.

change to a thor channel (this is not required but helps for other reasons)
menu
installation
service searching
manual search
ok on antenna alternative
diseqc commande change to installer
up to sat name and change to reference
motor control change to goto,ok.     wait for dish to alter(1deg) this is a chance to visually check if you wish by climbing the ladder.
now change motor control to reset,   you will get a warning all will be reset, press ok
back up to sat name change back to the sat you were on
diseqc command change to user
exit 

now load the latest, 45east-43west_diseqcmotor.hnf

ok
yellow
yellow
and work up and down the sat list
choose each one
ok
ok on channel name
identify hopefully by the name on screen
then fine tune if needed
please read the other txt files included in the zip for more info

TIP
if you have started on a sirius channel, after performing the goto reference(sat name) if you watch the signal quality bar you can see how well your dish is aligned.
while on reference you can fine tune back to sirius and see how much difference there is, i believe that each step in fine tuning is a tenth of a degree. after this little tweak you can then goto reference again to complete the above.
hope this helps.

Thanks to voith driver for this info.
